Portland Oregon Road Conditions

Filters

Note: Available filter options are derived from active events; the absence of a filter option indicates no active events contain that information.

Current Travel Conditions By Route

I-405: MP 1.96
I-405, Intersection with US26

Commercial Vehicle Information
Informational only
Details
I-405 MP 1.97 SW Taylor St crossing over I-405 (Portland) Effective June 18, 2020, SW Taylor Street crossing over I-405 is restricted to 20,000 lbs. single axle, 34,000 lbs. tandem axle, 105,500 GVW, Weight Table 2.
Last Updated
1/29/2023 7:00 PM

US26: MP 0.34
US26, I-405

Commercial Vehicle Information
Informational only
Details
US26 WB Connector Road to OR99W (Barbur Blvd) SB MP 0.58 (crossing US26 and Grover St - Portland) Effective September 29, 2022, the US26 WB State Connector Road crossing over US26 EB and Grover Street is restricted to the following weights: 36 tons for SU7 (7 axle single-unit trucks). This bridge is not on the US26 mainline.
Last Updated
1/29/2023 7:00 PM

US26: MP 0.99
US26, 1 mile East of I-405

Construction Work
No to Minimum Delay
Comments
Expect nighttime single lane closures on U.S. 26 in both directions on the east end of the Ross Island Bridge near OR 99E. Crews are installing protective screening on both sides of the east end of the Ross Island Bridge. <!--Links Start Here--> [Link to Additional Information](https://www.oregon.gov/odot/projects/pages/project-details.aspx?project=19918)
Last Updated
11/04/2022 3:50 PM

US26: EB MP 71.3 to 66.5
US26, Beaverton, Intersection with Camelot

Construction Work
No to Minimum Delay
Comments
No traffic impacts.
Last Updated
11/21/2022 6:26 AM

US30: MP 3.94 to 6.51
US30, Portland

Construction Work
Estimated delay under 20 minutes
Comments
No traffic impacts. We are making safety improvements for people walking, biking, rolling, driving and moving freight on U.S. 30 (NW St. Helens Road), between NW Bridge Avenue and NW Kittridge Avenue. We are repaving the roadway, replacing traffic signals, adjusting vehicle lane widths, building curb ramps to meet Americans with Disabilities Act (ADA) requirements and improving conditions for people biking.
Last Updated
12/18/2022 5:12 PM

ORE141: MP 2.83 to 4.09
ORE141, Intersection with Beaverton - Tigard Highway ORE217

Construction Work
Estimated delay under 20 minutes
Comments
Daytime single lane closures from Scholls Ferry Road to Greenburg Road 8:30 a.m. to 3:30 p.m. weekdays. Daytime lane closures on Scholls Ferry Road from 8:30 a.m. to 3:30 p.m. weekdays.
Last Updated
1/29/2023 9:06 AM

ORE217: SB MP 2 to 6
ORE217, 2 miles South of US 26

Construction Work
Estimated delay of 20 minutes - 2 hours
Comments
Nighttime lane closure on OR 217 south between Allen Boulevard and Denney Road Thursday. The right turn lanes on the OR 99W southbound off-ramp and the Greenburg Road northbound off-ramp are closed for several months. Right turns permitted from the middle lane. Auxiliary lane closures on OR 217 south from Scholls Ferry Road to OR 99W. Daytime shoulder closures on OR 217 and local roads near the highway ramps. On- and off-ramps temporarily narrowed. Pedestrian detours on the north side of Hall Boulevard near Cascade Avenue, the north side of the Denney Road overpass and the north side of the Denney Road overpass.
Last Updated
1/23/2023 6:09 AM

ORE217: MP 2.26 to 2.7
ORE217, 2 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB Exit 2B on- and off-ramps to/from Allen Blvd (Beaverton) Effective January 1, 2022, the OR217 southbound Exit 2B on- and off-ramps to/from Allen Boulevard will be intermittently restricted to 13 feet 00 inches in width at all hours. Loads over 13 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this project is July 6, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 2.78 to 3.26
ORE217, 3 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB Exit 3 on- and off-ramps to/from Denney Rd (Beaverton) Effective May 19, 2022, the OR217 southbound Exit 3 on- and off-ramps to/from Denney Road will be intermittently restricted to 14 feet 00 inches in width at all hours. Mobile homes with eaves are allowed provided the base width does not exceed 14 feet 00 inches in width. Loads over 14 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this work is March 6, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 3.56
ORE217, 4 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB Exit 4A off-ramp to Hall Blvd (Beaverton) Effective January 24, 2022, the OR217 southbound Exit 4A off-ramp to Hall Boulevard will be intermittently restricted to 13 feet 00 inches in width at all hours. Loads over 13 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this project is March 31, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 3.83
ORE217, 4 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB on-ramp from Hall Blvd (Beaverton) Effective January 19, 2022, the OR217 southbound on-ramp from Hall Boulevard will be intermittently restricted to 13 feet 00 inches in width at all hours. Loads over 13 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this project is March 31, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 4.12 to 4.51
ORE217, 4 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB Exit 4B on- and off-ramps to/from OR210/Scholls Ferry Rd (Beaverton) Effective January 19, 2022, the OR217 southbound Exit 4B on- and off-ramps to/from OR210/Scholls Ferry Road will be intermittently restricted to 13 feet 00 inches in width at all hours. Loads over 13 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this project is March 31, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 4.78 to 5.17
ORE217, 5 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB on-ramp from Greenburg Rd (Beaverton) Effective January 26, 2022, the OR217 southbound on-ramp from Greenburg Road will be intermittently restricted to 13 feet 00 inches in width at all hours. Loads over 13 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this project is March 31, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 5.13
ORE217, 5 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 NB Exit 5 off-ramp to Greenburg Rd (Tigard) Effective November 4, 2022, the OR217 northbound Exit 5 off-ramp to Greenburg Road will be restricted to 14 feet 00 inches in width at all hours. Mobile homes with eaves are allowed provided the base width does not exceed 14 feet 00 inches in width. The estimated completion date for this work is February 4, 2023.
Last Updated
1/29/2023 7:00 PM

ORE217: MP 5.69
ORE217, 6 miles South of US 26

Commercial Vehicle Information
Informational only
Details
OR217 SB Exit 6 off-ramp to OR99W (Tigard) Effective November 4, 2022, the OR217 southbound Exit 6 off-ramp to OR99W will be restricted to 14 feet 00 inches in width at all hours. Mobile homes with eaves are allowed provided the base width does not exceed 14 feet 00 inches in width. The estimated completion date for this work is February 4, 2023.
Last Updated
1/29/2023 7:00 PM

ORE224: EB MP 0.01 to 4.11
ORE224, Intersection with Pacific Highway East ORE 99E (McLoughlin Blvd)

Construction Work
Estimated delay under 20 minutes
Comments
No traffic Impacts. Project Description: We are installing modern traffic signal controllers, additional vehicle radar detection equipment and traffic monitoring cameras along Oregon 224 (Milwaukie Expressway) from SE 17th Avenue to I-205. We are also adding new thermal imaging sensors at five signalized intersections on OR 224 to detect bicyclists and trigger longer green lights, allowing them more time to cross wide intersections. The new equipment will allow ODOT engineers and technicians to monitor traffic signal performance, manage congestion and improve safety along this corridor.
Last Updated
12/25/2022 2:58 PM

ORE43: NB MP 0.19
ORE43, Intersection with Mount Hood Highway US26

Construction Work
No to Minimum Delay
Comments
Expect nighttime lane or ramp closures on northbound OR 43, the OR 43 ramp to U.S. 26/City Center, and I-5 south from 8 p.m. to 6 a.m. weeknights. Crews are installing new screening on the OR 43/Macadam Avenue ramp to U.S. 26/City Center over I-5. <!--Links Start Here--> [Link to Additional Information](https://www.oregon.gov/odot/projects/pages/project-details.aspx?project=19918)
Last Updated
11/04/2022 3:46 PM

ORE8: MP 2.65 to 3.6
ORE8, Highway 217

Commercial Vehicle Information
Informational only
Details
OR8 EB & WB MP 2.67 to MP 3.60 (Beaverton) Effective August 15, 2022, this section of OR8 (Tualatin Valley Highway) will be restricted to 10 feet 00 inches in width Monday through Friday nights between the hours of 8:00 PM and 5:00 AM. Loads over 10 feet 00 inches in width may be accommodated on a case-by-case basis. Contact the Over-Dimension Permit Unit for information. The estimated completion date for this work is May 31, 2023.
Last Updated
1/29/2023 7:00 PM

ORE8: MP 2.81 to 7
ORE8, Highway 217

Construction Work
No to Minimum Delay
Comments
Nighttime lane closures from 8 p.m. to 5:30 a.m. Monday through Friday at SW Hall, SW Watson, 110th, 117th and Lombard. Watch for flaggers directing traffic. One lane of OR 8 east closed around-the-clock between Short Street and Watson Avenue beginning Wednesday. Daytime and nighttime single lane closures from 8 a.m. to 2 p.m. and 7:30 p.m. to 6:30 a.m. at SW 192nd Monday through Friday. Shoulder closures with pedestrian detours.
Last Updated
1/29/2023 9:04 AM

ORE99: MP -0.36
ORE99W, Portland

Commercial Vehicle Information
Informational only
Details
OR99W MP -0.36 (Steel Bridge - Portland) Effective October 28, 2019, OR99W crossing the Steel Bridge in Portland is restricted to the following weights: 20,000 lbs. single axle, 34,000 lbs. tandem axle, Weight Table 2 & for Non-Divisible Loads 21,500 lbs. single axle, 43,000 lbs. tandem axle, 98,000 lbs. GVW, Weight Table 3.
Last Updated
1/29/2023 7:00 PM

ORE99: MP 1.41
ORE99W, I-405 South Interchange

Commercial Vehicle Information
Informational only
Details
OR99W (Pacific Hwy) MP 1.41 (Arthur Street Bridge - Portland) OR99W crossing Arthur Street Bridge at MP 1.41 is restricted to the following weights: 33 tons for SU6 (6 axle single-unit trucks); and 34 tons for SU7 (7 axle single-unit trucks).
Last Updated
1/29/2023 7:00 PM

ORE99: MP 3.25
ORE99W, Intersection with Beaverton - Hillsdale Highway ORE10

Commercial Vehicle Information
Informational only
Details
OR99W MP 3.25 (Newbury St Viaduct - Portland) Effective September 29, 2022, OR99W crossing over Newbury Street Viaduct at MP 3.25 is restricted to the following weights: 20 tons for Type 3 vehicles (3 axle single-unit trucks); 18 tons for SU4 (4 axle single-unit trucks); 20 tons for SU5 (5 axle single-unit trucks); 23 tons for SU6 & SU7 (6 and 7 axle single-unit trucks); 30 tons for Type 3S2 (truck tractor/semitrailer); 40 tons for Type 3-3 (truck and trailer). This bridge is also restricted to the following weights: 20,000 lbs. single axle; 34,000 lbs. tandem axle; 80,000 lbs. GVW; Weight Table 1 for combinations.
Last Updated
1/29/2023 7:00 PM